Hyundai Santa Fe (TM): Hood / Hood Latch. Components and components location
| Component Location |
| 1. Hood Latch Assembly |
Replacement 1. Using a socket (B), remove the hood release handle (A). 2. To install, reverse removal procedure.
Replacement 1. Remove the front bumper assembly. (Refer to Front Bumper - "Front Bumper Assembly") 2.
Other information:
Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Repair procedures
Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance compensation if you do any of the following.
Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Parking/View Switch. Repair procedures
Removal • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Categories
- Manuals Home
- Hyundai Santa Fe Owners Manual
- Hyundai Santa Fe Service Manual
- Unlocking your vehicle
- Four Wheel Drive (4WD) mode selection
- Forward Collision-Avoidance Assist Settings
- New on site
- Most important about car
