Hyundai Santa Fe (TM): Charging System / Battery Sensor. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Engine Electrical System / Charging System / Battery Sensor. Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery (-) terminal.
2.
Disconnect the battery sensor connector (A).
3.
Remove the battery sensor (A).
Tightening torque :
26.5 - 32.4 N.m (2.7 - 3.3 kgf.m, 19.5 - 23.9 Ib-ft)

Installation
1.
Install in the reverse order of removal.
  
•
For the vehicle equipped with a battery sensor, be careful not to damage the battery sensor when the battery is replaced or recharged.
1)
When replacing the battery, the new battery should be of the same type, capacity and brand with the previous one. If a battery of a different type is replaced, the battery sensor may recognize the battery to be abnormal.
2)
When installing the ground cable on the negative post of battery, tighten the clamp to the specified torque. An excessive tightening can damage the PCB internal circuit and the battery terminal.
3)
When recharging the battery, ground the negative terminal of the booster battery to the vehicle body.
Adjustment
Battery Sensor Recalibration Procedure
After reconnecting the battery negative cable, AMS function does not operate until the system is stabilized, for about 4 hours. If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with AMS function, Battery sensor recalibration procedure should be performed after finishing the repair work.
1.
Turn the Iginition switch ON and OFF.
2.
Park the vehicle for about 4 hours with the hood and all doors closed.

    Description Vehicles have many control units that use more electricity. These units control their own system based on information from various sensors.

    Description and operation Description Due to the considerably more frequent occurrence of starting operations, the electrical load that occurs often leads to voltage dips in the vehicle network.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Smart Cruise Control (SCC) Switch. Repair procedures

    Inspection 1. Check for resistance between terminals in left switch position. [Audio/Bluetooth] Switch Connector terminal Resistance (± 3%) SEEK Up 1 - 6 430 Ω

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Driver Parking Assistance System

    Desctiprion and operation Description ADAS_PRK is a unit that controls the functions required for ADAS parking. If the ADAS_PRK is applied, the parking distance warning function is also controlled by the ADAS_PRK. System Function Parking Collision-Avoidance Assist (PCA) PCA is a parking safety system

    Categories

     
    Copyright © 2026 www.hsafe4.com - 0.029