| Components |

| 1. Tie rod end 2. Lead wire |
3. Short gear 4. Power pack |

| 1. Steering gera
box |
2 Tie rod end |
Removal [C-MDPS] 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2.
Removal and installation • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
Heater Unit. Components and components location Component Location 1. Heater Unit Assembly Components 1. Heater unit assembly 2. Heater NVH pad 3. Heater seal duct 4.
Inspection 1. Check for resistance between terminals in left switch position. [Audio/Bluetooth] Switch Connector terminal Resistance (± 3%) SEEK Up 1 - 6 430 Ω