Hyundai Santa Fe: Cylinder Block / Drive Plate. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Engine Mechanical System / Cylinder Block / Drive Plate. Repair procedures

Removal and Installation

•	Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift. (Refer to General Information - "Lift and Support Points")

1.	Remove the automatic transaxle . (Refer to Automatic Transaxle System - "Automatic Transaxle")

Remove the drive plate (A) and the adapter plate (B).

Tightening torque :

127.5 - 137.3 N.m (13.0 - 14.0 kgf.m, 94.0 - 101.3 lb-ft)

•	Always use new drive plate (or flywheel) bolts.

•

Apply sealant to the screw part (10mm from the end of the bolt) when reusing the drive plate bolts.

Sealant : MS721 - 39, D

•	Install and uniformly tighten the 7 bolts, in several passes.

3.	Install in the reverse order of removal.

Cylinder Block

Rear Oil Seal. Repair procedures

Removal • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: License Lamps. Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens (A) from the panel after loosening a screw. 3. Replace the bulb (B) after removing the license lamp (A)...

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: System operation

Warning and control Lane Following Assist If the vehicle ahead and/or both lane markings are detected and your vehicle speed is below 110 mph (180 km/h), the green indicator light will illuminate on the cluster, and the system will help center the vehicle in the lane by assisting the steering wheel...