Hyundai Santa Fe (TM): Advanced Driver Assistance System (ADAS) / Rear View Monitor (RVM)

Description and operation

Description
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the H/UNIT or the ECM (Reverse Display Room Mirror) mirror while backing-up.
  
This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.

Components and components location

Component Location

1. Rear view camera
2. H/UNIT

Schematic diagrams

Circuit Diagram

Repair procedures

Removal
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
2.
Remove the tailgate ganish (A).

3.
Remove the tailgate switch assembly.

4.
Remove the license lamp LH.

5.
Disconnector the connector (A) and then remove the rear view camera.

Installation
1.
Install the rear view camera.
2.
Install the and tailgate trim.

    Description and operation Description The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column.

    Desctiprion and operation Description ADAS_PRK is a unit that controls the functions required for ADAS parking. If the ADAS_PRK is applied, the parking distance warning function is also controlled by the ADAS_PRK.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Panorama Sunroof

    Components and components location Component Location 1. Panorama sunroof 2. Panorama sunroof switch 3. Panorama sunroof motor & controller 4. Roller blind motor & slave controller Schematic diagrams Circuit Diagram Connector Pin Information No

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor consists of a thermistor that measures the inside temperature. The signal decided by the resistance value that changes in accordance with perceived inside temperature, is delivered to heater control unit, and according t

    Categories

     
    Copyright В© 2026 www.hsafe4.com - 0.018