Hyundai Santa Fe: Rear View Monitor (RVM) / Description and operation
Back view camera will activate when the backup light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the
H/UNIT or the ECM (Reverse Display Room Mirror) mirror while backing-up.
This system is a supplementary function only. It is the responsibility
of the driver or always check the inside/ outside rearview mirror and
the area behind the vehicle before and while backing up because there
is a dead zone that can't see through the camera.
|
Other information:
Inspection
•
Refer to the DTC manual for the check procedure.
Removal
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Replacement
[TPMS Receiver (integrated Body control Unit (IBU))]
1.
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
2.
Remove the glove box.
(Refer to Body - "Glove Box")
3...
Categories
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
WARNING
NEVER allow children in the vehicle unattended. The power seats are operable
when the vehicle is turned off.
read more