Hyundai Santa Fe: Coupling Assembly / Pressure Sensor. Description and operation

Hyundai Santa Fe (TM) 2019-2025 Service Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Pressure Sensor. Description and operation

Description
The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generated torque into rear wheels. Its torque value varies according to a pressure status.
Component location

    Oil hydraulic Motor(Actuator). Repair procedures

    Inspection    • If you have trouble code related to the oil hydraulic motor (actuator), check oil hydraulic motor (actuator) according to the inspection process...

    Pressure Sensor. Schematic diagrams

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Rear Glass. Repair procedures


    Removal    • In order to remove rear glass, use tools as follows shown in the picture. [Tools block diagram] ① Square wire ② Insert type wire grip [Tools assembly diagram] • Tighten square wire ① inserting it in the hole of Insert type wire grip ② 1...

    Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Floor mat anchor(s)


    ALWAYS use the Floor Mat Anchors to attach the front floor mats to the vehicle. The anchors on the front floor carpet keep the floor mats from sliding forward. WARNING Do not overlay additional mats or liners over the floor mats. If using All Weather mats, remove the carpeted floor mats before installing them...

    Categories

    Air bag collision sensors

    WARNING

    To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

    Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.

    read more


     
    Copyright © 2025 www.hsafe4.com