| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front door trim")
|
| 3. |
Disconnect the power door mirror connector from the harness
BCW indicator
|
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the door mirror assembly.
(Refer to Body - "Outside Rear View Mirror")
|
| 3. |
Using a fastener remover (C), remove the mirror (A) as illustration
below.
|
| 4. |
Disconnect heat wire and BCW connectors (A) and then remove the mirror.
|
| Installation |
| 1. |
Connect mirror heat wire connector and BCW connector then mount mirror.
|
| 2. |
Install the door mirror assembly.
|
| 3. |
Connect (-) battery terminal then check if door mirror lamp works normally.
|

The armrest is located in the center of the rear seat. Pull the armrest down from the seatback to use it.