Hyundai Santa Fe: Rear Wiper/Washer / Rear Washer Switch. Repair procedures
1. |
Check for continuity between the terminals in each switch position as
shown below.

Switch
|
Switch position
|
Switch terminal
|
Resistance (Ω, ±3.5%)
|
Front wiper switch
|
MIST
|
1-9
|
330
|
OFF
|
∞
|
INT (AUTO)
|
800
|
LOW
|
1800
|
HIGH
|
5700
|
Front wiper intermittent volume
|
Volume 1
|
7-9
|
330
|
Volume 2
|
690
|
Volume 3
|
1310
|
Volume 4
|
2610
|
Volume 5
|
7310
|
Rear wiper switch
|
OFF
|
4-16
|
∞
|
LOW
|
910
|
HIGH
|
2000
|
Fog lamp switch
|
OFF
|
9-10
|
∞
|
Front foglamp
|
910
|
Rear foglamp
|
2910
|
Turn signal switch
|
OFF
|
9-12
|
∞
|
Left
|
910
|
Right
|
2910
|
Dimmer & Passing switch
|
OFF
|
9-13
|
∞
|
Passing
|
910
|
Dimmer
|
2910
|
Light switgh
|
OFF
|
9-14
|
680
|
AUTO / DRL
|
∞
|
Tail lamp
|
1680
|
Low beam
|
5580
|
|
Inspection (With diagnostic tool)
1. |
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (diagnostic tool).
The diagnostic system (diagnostic tool) provides the following information.
(1) |
Fault Code Searching : Checking failure and code number (DTC)
|
(2) |
Data Analysis : Checking the system input/output data state
|
(3) |
Actuation test : Checking the system operation condition
|
(4) |
S/W Management : Controlling other features including system
option setting and zero point adjustment
|
|
2. |
If diagnose the vehicle by diagnostic tool, select "DTC Analysis" and
"Vehicle".

|
3. |
If check current status, select the "Data Analysis" .

|
4. |
Select the 'IBU_BCM' to search the current state of the input/output
data.


|
Inspection
Rear Wiper Motor
1.
Remove the connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 2
and 1 respectively...
Inspection
1.
With the washer motor connected to the reservoir tank, fill the reservoir
tank with water.
Before filling the reservoir tank with water, check the filter
for foreign material or contamination...
Other information:
Setting functions for the system
Turning the system ON/OFF
With the engine on, shortly press the Lane Driving Assist button located on the
steering wheel to turn on Lane Following Assist. The white or green
indicator light will illuminate on
the cluster...
Schematic Diagram
Canister
Canister is filled with charcoal and absorbs evaporated vapor in fuel tank.
The gathered fuel vapor in canister is drawn into the intake manifold by the
ECM/PCM when appropriate conditions are set...
Categories

1. Driver’s front air bag
2. Passenger’s front air bag
3. Side air bag
4. Curtain air bag
The vehicles are equipped with a Supplemental Air Bag System for the driver’s
seat and front passenger’s seats.
The front air bags are designed to supplement the three-point seat belts. For
these air bags to provide protection, the seat belts must be worn at all times when
driving.
read more