Hyundai Santa Fe (TM): Rear Suspension System / Rear Stabilizer Bar. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Suspension System / Rear Suspension System / Rear Stabilizer Bar. Repair procedures

Removal
1.
Raise the vehicle, and make sure it is securely supported.
2.
In the case of 4WD vehicle, remove the rear differential assembly.
(Refer to Driveshaft and axle - "Rear Differential Carrier")
3.
Remove the rear stabilizer link after loosening the mounting nut (A).
Tightening torque :
98.0 - 117.6 N.m (10.0 - 12.0 kgf.m, 72.3 - 86.7 lb-ft)

4.
Remove the rear stabilizer bar (A) after loosening the mounting bolts.
Tightening torque :
58.8 - 73.5 N.m (6.0 - 7.5 kgf.m, 43.4 - 54.2 lb-ft)

Inspection
1.
Check the rear stabilizer bar for deformation.
2.
Check the rear stabilizer link ball joint for damage.
Installation
1.
To install, reverse the removal procedures.
2.
Check the alignment.
(Refer to Suspension System - "Alingment")

    Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2.

    Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Blower Unit. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. When the engine is cool, drain the engine coolant from the radiator.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Front View Camera Unit. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the inside rear view mirror cover (A) and front view camera cover (B). 3.

    Categories

     
    Copyright В© 2025 www.hsafe4.com - 0.0207