Hyundai Santa Fe (TM): Rear Suspension System / Rear Assist Arm. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Suspension System / Rear Suspension System / Rear Assist Arm. Repair procedures

Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque :
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
  
•
Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

3.
Remove the rear assist arm (A) after loosening the mounting bolts and nuts.
Tightening torque :
Rear sub frame side : 137.3 - 156.9 N.m (14.0 - 16.0 kgf.m, 101.3 - 115.7 lb-ft)
Rear carrier side : 156.9 - 176.5 N.m (16.0 - 18.0 kgf.m, 115.7 - 130.2 lb-ft)
  
•
Set up the transmission jack under the lower arm in order to remove it in no-load condition.

Inspection
1.
Check the bushing for wear and deterioration.
2.
Check for all bolts and nuts.
Installation
1.
To install, reverse the removal procedures.
2.
Check the alignment.
(Refer to Suspension System - "Alingment")

    Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2.

    Removal 1. Raise the vehicle, and make sure it is securely supported. 2. In the case of 4WD vehicle, remove the rear differential assembly.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Evaporator Core. Repair procedures

    Replacement 1. Remove the rear heater & A/C unit. (Refer to Rear Heater - "Rear Heater Unit") 2. Loosen the mounting screws and remove the rear A/C lower case (A).

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Components and components location

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0149