Hyundai Santa Fe: Lighting System / Hazard Lamp Switch. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch. Repair procedures

Removal

1.	Disconnct the negative (-) battery terminal.

2.	Remove the A/C contrrol unit. (Refer to Heating, Ventilation and Air Conditioning - "Controller")

3.	Remove the hazzard lamp switch.

4.	Disconnect the connector and then remove the hazzard lamp switch.

Installation

1.	Install the hazzard lamp switch.

2.	Connect the negative (-) battery terminal.

Overhead Console Lamp. Repair procedures

Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch...

Rheostat. Components and components location

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Tail Gate Assembly. Repair procedures

Replacement • Wear gloves to protect hands from injury. • When removing and installing the tailgate, an assistant is needed...

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Crankshaft Position Sensor (CKPS). Description and operation

Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop because of CKPS signal missing...

Categories

Power adjustment

The front seat can be adjusted by using the control switches located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so that you can easily control the steering wheel, foot pedals and controls on the instrument panel.

WARNING

NEVER allow children in the vehicle unattended. The power seats are operable when the vehicle is turned off.