Hyundai Santa Fe: Rear Suspension System / Trailing Arm. Repair procedures
|
1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
|
2. |
Remove the rear wheel and tire (A) from rear hub.
|
Tightening torque :
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
|
|
• |
Be careful not to damage the hub bolts when removing
the rear wheel and tire (A).
|
|

|
|
3. |
Loosen the wheel speed sensor cable bracket mounting nuts (A).
|
Tightening torque :
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)
|

|
|
4. |
Loosen the wheel speed sensor cable bracket mounting bolts (A).
|
Tightening torque :
12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb-ft)
|

|
|
5. |
Loosen the trailing arm mounting bolts (A).
|
Tightening torque:
98.0 - 117.6 N.m (10.0 - 12.0 kgf.m, 72.3 - 86.7 lb-ft)
|

|
|
6. |
Remove the trailing arm (A) after loosening the mounting bolts.
|
Tightening torque :
117.7 - 137.3 N.m (12.0 -14.0 kgf.m, 86.8 - 101.3 lb-ft)
|

|
|
1. |
Check the bushing for wear and deterioration.
|
|
2. |
Check for all bolts and nuts.
|
|
1. |
To install, reverse the removal procedures.
|
|
2. |
Check the alignment.
(Refer to Suspension System - "Alingment")
|
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2...
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2...
Other information:
Front air bags
Front air bags are designed to inflate in a frontal collision depending on the
severity of impact of the front collision.
Side and curtain air bags
Side and curtain air bags are designed to inflate when an impact is detected
by side collision sensors depending on the severity, speed or angles of impact resulting
from a side impact collision...
TCM Connector and Terminal
Function
TCM Terminal Function
Connector [A]
Pin No
Description
Connected to
1
Power ground
Chassis Ground
2
-
-
3
-
-
4
-
-
5
-
-
6
Fuel Sender Signal
Fuel Sender
7
-
-
8
-
-
9
-
-
10
-
-
11
-
-
12
-
-
13
-
-
14
-
-
15
Stop Lamp Signal
Stop Lamp
16
Brake Test Switch
Brake Switch
17
18
-
19
-
20
Output Speed (Supply)
ATM Solenoid Valve (Otput Speed)
21
Input Speed (Supply)
ATM Solenoid Valve (Input Speed)
22
-
-
23
-
-
24
-
-
25
-
-
26
-
-
27
[A/T] SOL...
Categories
Electric Power Steering (EPS) warning light
.png)
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The electric power steering warning light illuminates for about 3 seconds
and then goes off.
Whenever there is a malfunction with the electric power steering.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
read more