Hyundai Santa Fe (TM): Power Tailgate Module / Power Tailgate Unit. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Body Electrical System / Power Tailgate Module / Power Tailgate Unit. Repair procedures

Removal
  
1)
After replacing with a new power tailgate module, check for DTC code at all times.
If DTC code B24B0 exists, perform power tailgate mode change.
(Refer to Power Tailgate Module - "Troubleshooting")
2)
After replacing with a new power tailgate module, perform the system initialization.
(Refer to Power Tailgate Module - "Troubleshooting")
3)
Before delivery to customer, operate the power tailgate to be sure that there is no warning sound.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear left luggage side trim.
(Refer to Body - "Luggage Side Trim")
3.
Remove the power tailgate unit connectors (A).
4.
Remove the power tailgate unit (A).

Installation
1.
Install the power tailgate unit.
Tightening torque :
4.9 - 7.8 N.m (0.5 - 0.8 kgf.m, 3.6 - 5.8 lb-ft)
2.
Install the rear left luggage side trim.
3.
Connect the negative (-) battery terminal.

    Circuit Diagram

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the tailgate trim.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: PTC Heater (Diesel only). Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the mode to FLOOR. (2) Set the temperature to MAX HOT.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Blower Resistor (Manual). Repair procedures

    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Categories

     
    Copyright В© 2025 www.hsafe4.com - 0.017