Hyundai Santa Fe (TM): Parking Brake System. Electronic Parking Brake (EPB) / Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Brake System / Parking Brake System. Electronic Parking Brake (EPB) / Repair procedures

Removal
  
•
Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
(Refer to General Information - "Lift and Support Points")
[EPB Switch]
1.
Turn ignition switch off and disconnect the battery (-) cable from the battery.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor Console")
3.
Disconnect the EPB switch connector (A).
4.
Remove the EPB switch (A) after loosening the screw.
[EPB Actuator]
1.
Turn ignition switch off and disconnect the battery (-) cable from the battery.
2.
Remove the rear wheel and tire.
3.
Remove the EPB actuator from rear caliper.
(Refer to Brake System - "Rear Disc Brake")

    Circuit Diagram Terminal Function Pin No Fuction Pin No Fuction 6 Electrical parking brake signal 1 2 Rear right EPB motor power 7 Electrical parking brake signal 2 3 Rear right EPB motor ground 8 Electrical parking brake signal 3 12 Rear left EPB motor ground 9 Electrical parking brake signal 4 13 Rear left EPB motor power

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Repair procedures

    Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance compensation if you do any of the following.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Cruise Control (CC) Switch. Components and components location

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.015