Hyundai Santa Fe (TM): Engine Control System / Intake Air Temperature Sensor (IATS). Description and operation

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Engine Control/Fuel System / Engine Control System / Intake Air Temperature Sensor (IATS). Description and operation

Description
Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature.
To calculate precise air quantity, correction of the air temperature is needed because air density varies according to the temperature. So the ECM uses not only MAPS signal but also IATS signal. This sensor has a Negative Temperature Coefficient (NTC) Thermister and it's resistance changes in reverse proportion to the temperature.

    Inspection 1. Connect the diagnostic tool on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON.

    Specification Temperature [°C (°F)] Resistance (kΩ) -40 (-40) 40.93 - 48.35 -20 (-4) 13.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Troubleshooting

    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Corner Radar System

    Description and operation Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.

    Categories

     
    Copyright © 2026 www.hsafe4.com - 0.0222