| Troubleshooting |
| Problem Symptoms Table |
|
Symptom |
Suspected Area |
|
No blower operation |
1. Blower fuse |
|
2. Blower relay |
|
|
3. Blower motor |
|
|
4. Power mosfet |
|
|
5. Blower speed control switch |
|
|
6. Wire harness |
|
|
No air temperature control |
1. Engine coolant capacity |
|
2. Heater control assembly |
|
|
No compressor operation |
1. Refrigerant capacity |
|
2. A/C fuse |
|
|
3. Clutch limiter |
|
|
4. Compressor |
|
|
5. A/C pressure transducer |
|
|
6. A/C switch |
|
|
7. Evaporator temperature sensor |
|
|
8. Wire harness |
|
|
Vented air not cold |
1. Refrigerant capacity |
|
2. Refrigerant pressure |
|
|
3. Drive belt |
|
|
4. Clutch limiter |
|
|
5. Compressor |
|
|
6. A/C pressure transducer |
|
|
7. Evaporator temperature sensor |
|
|
8. A/C switch |
|
|
9. Heater control assembly |
|
|
10. Wire harness |
|
|
Insufficient cooling |
1. Refrigerant capacity |
|
2. Drive belt |
|
|
3. Clutch limiter |
|
|
4. Compressor |
|
|
5. Condenser |
|
|
6. Expansion valve |
|
|
7. Evaporator |
|
|
8. Refrigerant lines |
|
|
9. A/C pressure transducer |
|
|
10. Heater control assembly |
|
|
No engine idle-up when A/C switch ON |
1. Engine ECM |
|
2. Wire harness |
|
|
No air inlet control |
1. Heater control assembly |
|
No mode control |
1. Heater control assembly |
|
2. Mode actuator |
|
|
No cooling fan operation |
1. Cooling fan fuse |
|
2. Fan motor |
|
|
3. Engine ECM |
|
|
4. Wire harness |
Specification Air Conditioner Item Specification Compressor Type 7HVe17 Oil type & Capacity Single (Front only) FD46XG(IDMITSU) 100± 10cc (3.
Troubleshooting Troubleshooting Symptom Possible cause Remedy Speedometer does not operate Cluster fuse (10A) blown Check for short and replace fuse Speedometer faulty Check speedometer CAN line faulty
Heater Unit. Components and components location Component Location 1. Heater Unit Assembly Components 1. Heater unit assembly 2. Heater NVH pad 3. Heater seal duct 4.