Hyundai Santa Fe: IMS (Integrated Memory) / IMS Control Switch. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body Electrical System / IMS (Integrated Memory) / IMS Control Switch. Repair procedures

Inspection

1.	Disconnect the IMS control switch connector.

2.	With the power IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the IMS control switch.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Disconnect the IMS switch connector and then remove the IMS switch (A).

Installation

–	Make sure that the IMS control switch connectors and related connectors are plugged in properly.

–	Check the IMS control switch operates normally.

1.	Connect the connectors and reassemble the IMS control switch.

2.	Reassemble the front door trim.

IMS Control Switch. Components and components location

Seat Electrical

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: 35R Clutch Control Solenoid Valve (35R/C_VFS). Specifications

Specifications ▷ Control type : Normally low type Shape Items Specifications Control current [mA] 0 - 1100 Supply pressure [kpa (kgf/cm², psi)] 1569...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Battery. Specifications

Specification ▷ CMF68L-DIN Item Specification Model type CMF68L-DIN Capacity [20HR/5HR] (AH) 68 / 54 Cold Cranking Amperage (A) 600 Reserve Capacity (Min) 110 Specific Gravity 1...

Categories

Electric Power Steering (EPS) warning light. Charging system warning light

Electric Power Steering (EPS) warning light

This warning light illuminates:

When you set the ignition switch or the Engine Start/Stop button to the ON position.
- The electric power steering warning light illuminates for about 3 seconds and then goes off. Whenever there is a malfunction with the electric power steering.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.