Hyundai Santa Fe: IMS (Integrated Memory) / IMS Control Switch. Components and components location

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Body Electrical System / IMS (Integrated Memory) / IMS Control Switch. Components and components location

Components

    IMS (Integrated Memory System) module. Repair procedures

    Removal 1. Remove the negative (-) battery terminal. 2. Remove the front seat assembly...

    IMS Control Switch. Repair procedures

    Inspection 1. Disconnect the IMS control switch connector. 2. With the power IMS control switch in each position, make sure that continuity exists between the terminals below...

    Other information:

    Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: High Beam Assist (HBA)


    High Beam Assist will automatically adjust the headlight range (switches between high beam and low beam) depending on the brightness of detected vehicles and certain road conditions. Detecting sensor (Front view camera) [1] : Front view camera The front view camera is used as a detecting sensor to detect ambient light and brightness while driving...

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Rear Bumper Assembly. Repair procedures


    Replacement    • Put on gloves to prevent hand injuries.    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

    Categories

    Engine oil pressure warning light. Low fuel level warning light

    Engine oil pressure warning light

    This warning light illuminates:

    When the engine oil pressure is low.

    If the engine oil pressure is low:

    1. Drive carefully to the nearest safe location and stop your vehicle.

    2. Turn the engine off and check the engine oil level (For more details, refer to “Engine Oil” section in chapter 9). If the level is low, add oil as required.

    read more


     
    Copyright © 2025 www.hsafe4.com