Hyundai Santa Fe: Lighting System / High Mounted Stop Lamp. Repair procedures
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear spoiler.
(Refer to Body - "Rear Spoiler")
|
3. |
Remove the high mounted stop lamp cover (A).

|
4. |
Remove the high mounted stop lamp assembly (A) after loosening screws
(4EA).

|
1. |
Install the high mounted stop lamp.
|
2. |
Install the rear spoiler.
|
3. |
Connect the negative (-) battery terminal.
|
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp lens (A) from the panel after loosening a screw...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage room lamp lens (A) with a flat-tip screwdriver...
Other information:
Removal
1.
Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with
the diagnostic tool.
(Refer to 4WD Control System - "Repair Procedures")
2.
Turn OFF ignition switch and the disconnect the negative (-) battery
cable...
High Beam Assist indicator light
This indicator light illuminates:
When the high-beam is on with the light switch in the AUTO position.
White: When High Beam Assist is ready to operate.
Green: When High Beam Assist is operating.
If your vehicle detects oncoming or preceding vehicles, High Beam Assist will
switch the high beam to low beam automatically...
Categories
Electric Power Steering (EPS) warning light
.png)
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The electric power steering warning light illuminates for about 3 seconds
and then goes off.
Whenever there is a malfunction with the electric power steering.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
read more