Hyundai Santa Fe: High Beam Assist (HBA) / High Beam Assist Operation
Display and control
- After selecting ‘High Beam Assist’ in the Settings menu, High Beam
Assist will operate by following the procedure below.
- Place the headlight switch in the AUTO position and push the headlight lever
towards the instrument cluster. The High Beam Assist (
)
indicator light will illuminate on the cluster and the system will be enabled.
- When the system is enabled, high beam will turn on when vehicle speed is above
25mph (40km/h). When vehicle speed is below 15mph (25km/h), high beam will not
turn on.
- The High Beam (
) indicator light
will illuminate on the cluster when high beam is on.
- When High Beam Assist is operating, if the headlight lever or switch
is used, the system operates as follow:
- If the headlight lever is pulled towards you when the high beam is off, the
high beam will turn on without High Beam Assist canceled. When you let go of
the headlight lever, the lever will move to the middle and the high beam will
turn off.
- If the headlight lever is pulled towards you when the high beam is on by High
Beam Assist, low beam will be on and the system will turn off.
- If the headlight switch is placed from AUTO to another position (headlight/position/off),
High Beam Assist will turn off and the corresponding lamp will turn on.
- When High Beam Assist is operating, high beam switches to low beam
if any of the following conditions occur:
- When the headlight of an oncoming vehicle is detected.
- When the tail lamp of a vehicle in front is detected.
- When the headlight or tail lamp of a motorcycle or a bicycle is detected.
- When the surrounding ambient light is bright enough that high beams are not
required.
- When streetlights or other lights are detected.
With the engine on, select 'light -> High Beam Assist (or HBA (High Beam Assist))’
from the Settings menu to turn on High Beam Assist and deselect to turn off the
system...
High Beam Assist Malfunction
When High Beam Assist is not working properly, the ‘Check High Beam Assist (HBA)
system’ or ‘Check HBA (High Beam Assist system’ warning message will appear and
warning light will illuminate on the
cluster...
Other information:
Turn signal indicator light
This indicator light blinks:
When you operate the turn signal indicator stalk.
If any of the following occur, there may be a malfunction with the turn signal
system.
- The turn signal indicator light illuminates but does not blink
- The turn signal indicator light blinks rapidly
- The turn signal indicator light does not illuminate at all
If any of these conditions occur, have the vehicle inspected by an authorized
HYUNDAI dealer...
Auto defogging helps reduce the possibility of fogging up the inside of the windshield
by automatically sensing the moisture on inside the windshield.
The auto defogging system operates when the heater or air conditioning is on.
Information
The auto defogging system may not operate normally, when the outside temperature
is below 14°F (10°C)...
Categories
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
WARNING
NEVER allow children in the vehicle unattended. The power seats are operable
when the vehicle is turned off.
read more