| Circuit Diagram |



Specification HO2S [Bank 1 / Sensor 1] [Euro-V] Item Specification Heater Resistance (Ω) 2.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3.
Components and components location Component Location 1. Lumber support motor (Vertical) 2. Lumbar support motor (Horizontal) 3. Reclining motor 4. Rear height motor 5. Front height motor 6. Slide motor 7.
Removal 1. If a compressor is available, the air conditioner is operated for a few minutes in the engine idle state and then the engine is stopped. 2. Disconnect the negative (-) battery terminal.