Hyundai Santa Fe: Head Up Display System / Head Up Display Unit. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Body Electrical System / Head Up Display System / Head Up Display Unit. Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the instrument cluster.
(Refer to Indicators And Guages - "Instrument Cluster")
3.
Remove the head up display unit (A) after disconneting the connector (B) and loosening the mounting screws.
Installation
1.
Install the head up display unit.
2.
Install the instrument cluster.
3.
Connect the negative (-) battery terminal.
Inspection
If a part of the headup display footage is distorted or it is not at eye level with the driver a Global Diagnostic System (diagnostic tool) can be used to carry out calibration.
1.
In case calibration is required
–
When replacing the head-up display unit.
–
In case the footage is distorted after replacing the windshield (double vision removed after film is inner mounted to the glass).
–
When the HUD mounted main crashpad is removed/installed or replaced.
–
When the video installation location of the Head-up display unit is not at eye level of the driver and the focus is inconsistent.
2.
calibration items
No
Footage calibration functions
Calibration cases
1
 Rotation : Calibration in the half-circle/clockwise direction based on the center

2
 Smile : Calibration based vertically on the center

3
 Slanted(up/down) : Calibration according to an upward/downward slant

4
 Slanted(left/right) : Calibration according to a left/right slant

5
 Parallel compensation

6
 Move location of mark to upward/downward : Compensation according to eye height

7
 Initialization : Changed to the status of before video compensation

    Head Up Display Unit. Troubleshooting

    Troubleshooting Category Error symptoms inspection item Detailed inspection item Related parts Lighting • HUD not working • Lighting brightness not automatically controlled (no difference between day and night) • Check the lighting control • Check the ambient light sensor operation • Check the CAN communication • Check the lighting control in the cluster USM → If working, HUD has no problem...

    Rear Occupant Alert

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2024 Service Manual: Troubleshooting


    Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 5° TPS TPS 1 fault Replace it with TPS2 TPS 2 fault Replace it with TPS1 TPS 1, 2 fault Throttle valve stuck at 5° APS TPS 1 fault Replace it with TPS2 TPS 2 fault Replace it with TPS1 TPS 1, 2 fault Throttle valve stuck at 5°    • When throttle value is stuck at 5°, engine speed is limited at below 1,500rpm and vehicle speed at maximum 40 - 50 km/h (25 - 31 mph)...

    Hyundai Santa Fe (TM) 2019-2024 Service Manual: Delivery Pipe. Repair procedures


    Removal 1. Release the residual pressure in fuel line. Release the residual pressure in fuel line. 2. Turn the ignition switch OFF and disconnect the battery (-) terminal. 3...

    Categories

    Engine oil pressure warning light. Low fuel level warning light

    Engine oil pressure warning light

    This warning light illuminates:

    When the engine oil pressure is low.

    If the engine oil pressure is low:

    1. Drive carefully to the nearest safe location and stop your vehicle.

    2. Turn the engine off and check the engine oil level (For more details, refer to “Engine Oil” section in chapter 9). If the level is low, add oil as required.

    read more


     
    Copyright © 2024 www.hsafe4.com