Hyundai Santa Fe: Front View Camera System / Front View Camera Unit. Schematic diagrams

Variant Coding
When you need variant coding:
–
Replace Front View Camera with a new one
※ EOL Variant Coding and calibration required for new replacement
Front View Camera Variant Coding
Front view camera variant coding makes it possible to operate functions for
each vehicle type...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the inside rear view mirror cover (A) and front view camera cover
(B)...
Other information:
Removal and Installation
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Adjustment
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the lower crash pad.
(Refer to Body - "Crash Pad")
3...
Categories
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air
bags or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If
the location or angle of the sensors is altered, the air bags may deploy when
they should not or may not deploy when they should.
Installing bumper guards with nongenuine Hyundai or non-equivalent
parts may adversely affect the collision and airbag deployment performance.
Press the Engine Start/Stop button to the OFF or ACC position and
wait for 3 minutes when the vehicle is being towed to prevent inadvertent air
bag deployment.
Have all air bag repairs performed by an authorized HYUNDAI dealer.
read more