Hyundai Santa Fe: Front View Camera System / Front View Camera Unit. Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Advanced Driver Assistance System (ADAS) / Front View Camera System / Front View Camera Unit. Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the inside rear view mirror cover (A) and front view camera cover (B).
3.
Disconnect the front view camera unit connector (A).
4.
Separate the fixed points (A) of coupler, remove the front view camera (B).
Installation
  
•
Perform the camera calibration in the following case.
(Refer to Front View Camera System - "Repair Procedure")
–
If the front view camera is replaced with a new one.
–
If the front view camera is removed and mounted.
–
If the front view camera coupler of the windshield glass is deformed.
–
If the windshield glass is changed.
–
When a failure code (System Out of Calibration) occur.
1.
Install in the reverse order of removal.
2.
When if replacing the front view camera with a new one, perform the "Variant Coding" procedure by using the Diagnostic Tools.
3.
Perform the front view camera unit calibration.
(Refer to Repair procedures - "Service Point Target Auto Calibration (SPTAC)")

    Front View Camera Unit. Schematic diagrams

    ..

    Lane Safety Button. Schematic diagrams

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2024 Owner's Manual: Safety precautions


    Adjusting the seats so that you are sitting in a safe and comfortable position plays an important role for the safety of the driver and passengers, along with seat belts and air bags when in an accident. WARNING Do not use a cushion that reduces friction between the seat and the passenger...

    Hyundai Santa Fe (TM) 2019-2024 Service Manual: Underdrive Brake Control Solenoid Valve (UD/B_VFS). Repair procedures


    Inspection    • Refer to the DTC manual for the check procedure. Removal    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift...

    Categories

    Engine oil pressure warning light. Low fuel level warning light

    Engine oil pressure warning light

    This warning light illuminates:

    When the engine oil pressure is low.

    If the engine oil pressure is low:

    1. Drive carefully to the nearest safe location and stop your vehicle.

    2. Turn the engine off and check the engine oil level (For more details, refer to “Engine Oil” section in chapter 9). If the level is low, add oil as required.

    read more


     
    Copyright © 2024 www.hsafe4.com