Hyundai Santa Fe: Drive Belt System / Drive Belt Tensioner. Repair procedures
•
|
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift.
(Refer to General Information - "Lift and Support Points")
|
|
1. |
Remove the drive belt.
(Refer to Drive Belt System - "Drive Belt")
|
2. |
Remove the drive belt auto tensioner (A).
Tightening torque :
53.9 - 63.7 N.m (5.5 - 6.5 kgf.m, 39.7 - 47.0 lb-ft)
|

|
3. |
Install in the reverse order of removal.
|
Removal
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Removal and Installation
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Other information:
Specification
HO2S [Bank 1 / Sensor 1] [Euro-V]
Item
Specification
Heater Resistance (Ω)
2.5 - 4.0 [20°C (68°F)]
HO2S [Bank 1 / Sensor 1] [Except Euro-V]
A/F Ratio (λ)
Output Voltage (V)
RICH
Approx...
Description
TPMS Receiver : BCM(body control module) integrated management
1.
Mode
(1)
Virgin State
•
The receiver as a sole part is shipped in this state...
Categories

The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
read more