Hyundai Santa Fe (TM): Drive Belt System / Crankshaft Damper Pulley. Repair procedures

Removal and Installation
  
Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
(Refer to General Information - "Lift and Support Points")
1.
Remove the drive belt.
(Refer to Drive Belt System - "Drive Belt")
2.
Remove the crankshaft damper pulley (A).
Tightening torque :
114.7 - 120.6 N.m (11.7 - 12.3 kgf.m, 25.8 - 27.1 lb-ft) + [68° - 72°]

  
Install the SST (09231-3D100) to hold the ring gear after removing the dust cover.
1)
Remove the dust cover (A) on the bottom of the ladder frame.
2)
Loosen the transaxle mounting bolt (B).

3)
Adjust the length of the holder nuts so that the front plate of the holder puts in the ring gear teeth.
4)
Adjust the angle of the links so that the two transaxle mounting bolts can be fastened to the original mounted holes.
5)
Install the SST (09231-3D100) using the two transaxle mounting bolts and spacers. Tighten the bolts and nuts of the holder and links securely.

3.
Install in the reverse order of removal.

    Removal and Installation    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Climate Control Air Filter. Repair procedures

    Replacement 1. Remove the glove box. (Refer to Body - "Glove Box") 2. Remove the filter cover (A) by pressing the knob. 3. Replace the air filter (A) with a new one according to the direction of air filter.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Front View Camera Unit. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the inside rear view mirror cover (A) and front view camera cover (B). 3.

     
    Copyright © 2025 www.hsafe4.com - 0.0158