Hyundai Santa Fe: Intake And Exhaust System / Air Cleaner. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Engine Mechanical System / Intake And Exhaust System / Air Cleaner. Repair procedures

Removal and Installation

Air Cleaner Assembly

1.	Disconnect the battery negative terminal.

2.	Remove the engine cover. (Refer to Engine And Transaxle Assembly - “Engine Cover”)

3.	Remove the air duct (A).

Remove the air cleaner assembly.

(1)	Disconnect the breather hose A (A).

(2)	Disconnect the breather hose B (B).

(3)	Disconnect the air intake hose (C) and then remove the air cleaner assembly (D).

Tightening torque

Hose clamp :

2.9 - 4.9 N.m (0.3 - 0.5 kgf.m, 2.2 - 3.6 lb-ft)

Air cleaner bolts :

7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2 lb-ft)

5.	Install in the reverse order of removal.

Air Cleaner Element Replacement

1.	Open the air cleaner element cover (A) by lifting up the air cleaner element cover handle.

2.	Unlock the air cleaner element camshaft (A) by turning in the direction of arrow.

Replace the air cleaner element (A) with a new one.

•	Grab the handle then pull out the air cleaner element.

4.	Lock the air cleaner element camshaft and then close the air cleaner element cover.

Intake And Exhaust System

Intake Manifold. Repair procedures

Removal and Installation 1. Disconnect the battery negative teminal. 2. Remove the engine cover...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: Paddle shifter (Manual shift mode)

The paddle shifter is available when the shift button is in the D (Drive) position or the manual shift mode. With the shift button in the D position The paddle shifter will operate when the vehicle speed is more than 6 mph. Pull the [+] or [-] paddle shifter once to shift up or down one gear and the system changes from automatic mode to manual shift mode...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Fuel Pump Motor. Repair procedures

Removal 1. Remove the fuel pump. (Refer to Fuel System - "Fuel Pump") 2. Disconnect the fuel sender connector (A). 3. Release the fixing hook (A) and then remove fuel sender (B) in the arrow direction...