Hyundai Santa Fe: 4 Wheel Drive (4WD) System / 4WD Control System
Inspection
Measure the resistance of pressure
sensor
1.
Turn ignition switch OFF.
2...
Adjustment
Description
The friction material inside the coupling will degrade over time. Therefore,
corresponding compensation values must be referenced and entered after replacing
the controller or the coupling...
Other information:
If the engine stalls while driving
Reduce your speed gradually, keeping a straight line. Move cautiously
off the road to a safe place.
Turn on your hazard warning flasher.
Try to start the engine again. If your vehicle will not start, we recommend
that you contact an authorized HYUNDAI dealer or seek other qualified assistance...
Inspection
1.
Check the condenser fins for clogging and damage. If clogged, clean
them with water, and blow them with compressed air. If bent, gently
bend them using a screwdriver or pliers.
2...
Categories

The armrest is located in the center of the rear seat. Pull the armrest down
from the seatback to use it.
read more