Hyundai Santa Fe (TM): Automatic Transaxle System (SBC) / Special service tools

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Automatic Transaxle System (SBC) / Special service tools

Special Service Tools
Tool
(Number and Name)
Illustration
Use
09200-3N000
Engine support fixture
(Beam)

Removal and installation of the transaxle.Use this beam (SST No. : 09200-3N000) with the supporter (SST No. : 09200-L1100, 09200-L1200) and Adapter (SST No. : 09200-2W000).
09200-L1100
Engine support fixture (Rear)

Removal and installation of the transaxle.with the beam (SST No. : 09200-38001/3N000).
09200-L1200
Engine support fixture (Front)

Removal and installation of the transaxle.with the beam (SST No. : 09200-38001/3N000).
09200-2W000
Adapter

Removal and installation of the transaxle.with the beam (SST No. : 09200-38001/3N000).
09453-3L241
Oil seal installer

Installation of the differential oil seal in the transaxle case and housing side (2WD).[Using with bar (SST No.09231-H1100)]
Oil seal installer
09453-2W100

4WD : Installation of the differential oil seal in the housing side
[Using with bar (SST No.:09231-H1100)]
09231-H1100
Handle

Installation of the differential oil seal in the transaxle case and housing side.[Using with oil seal installer (SST No.:09452-26100)]
09480-A3800
Position switch neutral fixed pin

When installing the manual control lever on the inhibitor switch, used to align the neutral position.

    Specifications Item Specifications Engine type Gasoline 2.5 MPI Automatic transaxle type FF 6th Automatic transaxle (A6MF2-2) Drive type 2WD / 4WD Gear ratio 1st 4.

    Automatic Transaxle. Repair procedures Removal    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: IMS (Integrated Memory)

    Description and operation Description The optimal seat position set by the driver is memorized into the power seat unit by using IMS switch. In case of the position change, the seat can restore its preset position by IMS switch.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Auto Defogging Sensor. Repair procedures

    Inspection To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the rain sensor inner cover (A) and rain sensor cover (B).

    Categories

     
    Copyright © 2026 www.hsafe4.com - 0.0339