Hyundai Santa Fe (TM): Parking Safety / System operation

Operating button

Parking Distance Warning Off button

  • Press the Parking Distance Warning Off ( ) button to turn off Reverse Parking Distance Warning. Press the button again to turn on the system.
  • When Reverse Parking Distance Warning is off (button indicator light on), if you shift the gear to R (Reverse), the system will automatically turn on.

Reverse Parking Distance Warning

  • Reverse Parking Distance Warning will operate when the gear is in R (Reverse).
  • Reverse Parking Distance Warning detects a person, animal or object in the rear when the vehicle’s rearward speed is below 6 mph (10 km/h).

  • The corresponding indicator will illuminate whenever each ultrasonic senor detects a person, animal or object in its sensing range. Also an audible warning will sound.
  • When more than two objects are detected at the same time, the closest one will be warned with an audible warning.
  • The shape of the indicator in the illustration may differ from the actual vehicle.

    Reverse Parking Distance Warning will help warn the driver if an obstacle is detected within a certain distance when the vehicle is moving in reverse at low speeds.

    System malfunction After starting the engine, a beep will sound when the gear is shifted to R (Reverse) to indicate the system is operating normally. However, if one or more of the following occurs, first check whether the ultrasonic sensor is damaged or blocked with foreign material.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Mode Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 7.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Blower Motor. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim [RH]. (Refer to Body - "Luggage Side Trim") 3. Separate the blower motor connector (A) and loosen the mounting screws and remove the

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0101