Hyundai Santa Fe: Safe Exit Assist (SEA) / System malfunction and limitations

Hyundai Santa Fe (TM) 2019-2024 Owner's Manual / Driver assistance system / Driving Safety / Safe Exit Assist (SEA) / System malfunction and limitations

System malfunction

When Safe Exit Assist is not working properly, the ‘Check Blind-Spot Safety system(s)’ warning message will appear on the cluster, and the system will turn off automatically or the system will be limited. We recommend that the system be inspected by an authorized HYUNDAI dealer.

System disabled

When the rear bumper around the rear corner radar or sensor is covered with foreign material, such as snow or rain, or installing a trailer or carrier, it can reduce the detecting performance and temporarily limit or disable Safe Exit Assist.

If this occurs, the ‘Blind-Spot Safety system(s) disabled. Radar blocked’ warning message will appear on the cluster.

The system will operate normally when such foreign material or trailer, etc. is removed, and then the engine is restarted.

If the system does not operate normally after it is removed, we recommend that the system be inspected by an authorized HYUNDAI dealer.

WARNING

  • Even though the warning message does not appear on the cluster, Safe Exit Assist may not properly operate.
  • Safe Exit Assist may not properly operate in an area (e.g. open terrain) where any objects are not detected right after the engine is turned on, or when the detecting sensor is blocked with foreign material right after the engine is turned on.

CAUTION

Turn off Safe Exit Assist to install a trailer, carrier, etc., or remove the trailer, carrier, etc. to use Safe Exit Assist.

Limitations of the system

Safe Exit Assist may not operate normally, or the system may operate unexpectedly under the following circumstances:

  • Getting out of the vehicle where trees or grass are overgrown
  • Getting out of the vehicle where the road is wet
  • The approaching vehicle is very fast or very slow

WARNING

  • Safe Exit Assist may not operate normally if interfered by strong electromagnetic waves.
  • Safe Exit Assist may not operate for 3 seconds after the vehicle is started, or the rear corner radars are initialized.

    System operation

    Warning and control Collision warning when exiting vehicle When an approaching vehicle from the rear is detected, the ‘Watch (out) for traffic’ warning message will appear on the cluster, and an audible warning will sound...

    Driver Attention Warning (DAW)

    Basic function Driver Attention Warning will help determine the driver's attention level by analyzing driving pattern, driving time, etc. while vehicle is being driven...

    Other information:

    Hyundai Santa Fe (TM) 2019-2024 Service Manual: Description and operation


    Function Of Safety Power Window When driver door power window auto-up switch is operated, safety function is activated. 1. Safety function condition When detect the force of 100N (using the 10N/mm spring) during the window rising, window is reversed...

    Hyundai Santa Fe (TM) 2019-2024 Service Manual: Blower Resistor (Manual). Repair procedures


    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1...

    Categories

    Instrument panel overview

    1. Instrument cluster
    2. Driver’s front air bag
    3. Engine Start/Stop button
    4. Infotainment system
    5. Hazard warning lamp switch
    6. Climate control system
    7. Shift button
    8. ISG (Idle Stop and Go) button
    9. Auto Hold button
    10. Heated steering wheel button
    11. Drive mode button
    12. DBC (Downhill Brake Control) button
    13. Parking Safety button
    14. Parking/View button
    15. Air ventilation seat button
    16. Seat warmer
    17. Passenger’s front air bag
    18. Glove box
    19. Wireless charging system pad
    20. Cup holder
    21. AC inverter
    22. USB charger

    read more


     
    Copyright © 2024 www.hsafe4.com