Hyundai Santa Fe: Blind-Spot View Monitor (BVM) / System malfunction
When Blind-Spot View Monitor is not working properly, or the cluster display
flickers, or the camera image does not display normally, we recommend that the system
be inspected by an authorized HYUNDAI dealer.
WARNING
- The image shown on the cluster may differ from the actual distance
of the object. Make sure to directly check the vehicle's surroundings for safety.
- Always keep the camera lens clean. If the lens is covered with foreign
material, it may adversely affect camera performance and Blind- Spot View Monitor
may not operate normally.
Operating switch
Turn Signal switch
Blind-Spot View Monitor will turn on and off when the turn signal is turned on
and off.
Blind-Spot View Monitor
Operating conditions
When the left or right side turn signal turns on, the image in that direction
is displayed on the instrument cluster...
Other information:
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque :
107...
Removal
1.
Remove the left luggage side trim.
(Refer to Body - "Luggage Side Trim")
2.
Disconnect the connector (A) and then remove the release actuator (B).
3...
Categories
Speedometer
.png)
The speedometer indicates the speed of the vehicle and is calibrated in miles
per hour (MPH) and/or kilometers per hour (km/h).
Tachometer
.png)
read more