Hyundai Santa Fe: Advanced Driver Assistance System (ADAS) / Surround View Monitor (SVM)
Hyundai Santa Fe (TM) 2019-2025 Service Manual / Advanced Driver Assistance System (ADAS) / Surround View Monitor (SVM)
- Description and operation
- Components and components location
- Troubleshooting
- Repair procedures
- Surround View Monitor (SVM) Unit. Components and components location
- Surround View Monitor (SVM) Unit. Repair procedures
- Surround View Monitor (SVM) Camera. Components and components location
- Surround View Monitor (SVM) Camera. Repair procedures
- Parking/View Switch. Repair procedures
Ultrasonic Sensor. Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front/rear bumper...
Description and operation
Description
Surround View Monitor (SVM) is the system that allows video monitoring of 360
degrees around the vehicle. The system includes 4 ultra optical camera mounted
around the vehicle (front, both sides, rear)...
Other information:
Hyundai Santa Fe (TM) 2019-2025 Service Manual: CVVT (Continuously Variable Valve Timing) System. Description and operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, which makes better fuel economy and reduces exhaust gases (NOx, HC) and improves engine performance through reduction of pumping loss, internal EGR effect, improvement of combustion stability, improvement of volumetric efficiency, and increase of expansion work...
Hyundai Santa Fe (TM) 2019-2025 Service Manual: Troubleshooting
Troubleshooting Symptom Possible cause Countermeasure Wind noise around the door Arise the gap on weatherstrip Replace weatherstrip Water leaks from panorama sunroof Miss install of panorama sunroof frame weather strip and deforming Replace seal breakage Fill with sealant Wind noise on Panorama Sunroof Deflector deformation and deviation Replace or Remounting Noise while panorama sunroof is working (noise when opening or closing) Accumulation on the guide rail or rear rail Clean guide rail/rear rail and apply grease Tilt lever shoe excessive wear and breakage Replace tilt lever shoe Panorama Sunroof malfunction (Motor work, sunroof move partially or does not move Accumulation on the guide rail or rear rail 1...
Categories
- Manuals Home
- 4th Generation Santa Fe Owners Manual
- 4th Generation Santa Fe Service Manual
- Folding the side view mirror
- Troubleshooting
- Repair procedures
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.
Copyright © 2025 www.hsafe4.com