Hyundai Santa Fe: Starting System / Starter Relay. Repair procedures
1. |
Turn ignition switch OFF and disconnect the battery negative (-) terminal.
|
2. |
Remove the fuse box cover.
|
3. |
Remove the starter relay (A).
|
4. |
Check for continuity between the terminals (30 and 87) using an ohmmeter.
Terminal
|
Resistance
|
Measure
|
30 - 87
|
1 MΩ or higher
|
If there is continuity between the terminals, replace the relay.
|
|
5. |
Apply 12V to the terminal 85 and ground to the terminal 86 and then
check for continuity between the terminals (30 and 87).
Terminal
|
Resistance
|
Measure
|
30 - 87
|
1Ω or less
|
If there is no continuity between the terminals, replace the relay.
|
|
6. |
Install the starter relay.
|
7. |
Install the fuse box cover.
|
Removal
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Other information:
This warning light illuminates:
When you set the ignition switch or the Engine Start/Stop button to
the ON position.
- The low tire pressure warning light illuminates for approximately 3 seconds
and then goes off.
When one or more of your tires are significantly underinflated...
Operating conditions
Smart Cruise Control will operate when the following conditions are satisfied.
Basic function
The gear is in D (Drive)
The driver’s door is closed
EPB (Electronic Parking Brake) is not applied
Your vehicle speed is within the operating speed range
-- 5~110 mph (10~180 km/h): when there is no vehicle in front
-- 0~110 mph (0~180 km/h): when there is a vehicle in front
ESC (Electronic Stability Control), TCS (Traction Control System) or ABS
is on
ESC (Electronic Stability Control), TCS (Traction Control System) or ABS
is not controlling the vehicle
Engine rpm is not in the red zone
Forward Collision-Avoidance Assist brake control is not operating
Remote Smart Parking Assist brake control is not operating
Information
At a stop, if there is no vehicle in front of your vehicle, the system will
turn on when the brake pedal is depressed...
Categories
1. Inside door handle
2. Power window switches
3. Power window lock button/Electronic child safety lock button
4. Side view mirror folding button
5. Side view mirror control switch
6. Central door lock switch
7. Instrument panel illumination control switch
read more