Hyundai Santa Fe: Horn / Repair procedures

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Body Electrical System / Horn / Repair procedures

Removal

1.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover"

2.	Remove the bolts and disconnect the horn connectors (C), then remove the high pitch horn (B) and low pitch horn (A).

Installation

1.	Install the horns after connecting the horn connectors.

2.	Install the front bumper cover.

Inspection

Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal.

The horn should make a sound. If the horn fails to make a sound, replace it.

Horn Relay Inspection

1.	Remove the horn relay (A) from the engine room relay box.

2.	There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.

3.	There should be no continuity between the No.30 and No.87 terminals when power is disconnected.

Components and components location

Component Location 1. Horn switch 2. Horn relay (Engine room compartment) 3. Horn (Low pitch) 4. Horn (High pitch) 5...

AVN System

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Intake Actuator. Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh air position when connecting 12V to terminal 3 and grounding terminal 7...

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Repair procedures

Diagnosis with diagnostic tool 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (diagnostic tool). The diagnostic system (diagnostic tool) provides the following information...