Hyundai Santa Fe: Electronic Parking Brake (EPB) / Releasing the parking brake
To release EPB (Electronic Parking Brake):
1. Press the Engine Start/Stop button to the ON or START position.
2. Press the EPB switch while depressing the brake pedal.
Make sure the Parking Brake warning light goes off.
- Satisfy the following conditions
1. Ensure seat belts are fastened and the doors, hood and liftgate are closed.
2. With the engine running, depress the brake pedal and shift out of P (Park)
to R (Reverse), D (Drive) or Manual shift mode.
3. Depress the accelerator pedal.
Make sure the Parking Brake warning light goes off.
Information
- For your safety, you can engage EPB even though the Engine Stop/Start
button is in the OFF position (only if battery power is available), but you
cannot release it.
- For your safety, depress the brake pedal and release the parking
brake manually with the EPB switch when you drive downhill or when backing up
the vehicle.
NOTICE
- If the Parking Brake warning light is still on even though the EPB
has been released, have the system checked by an authorized HYUNDAI dealer.
- Do not drive your vehicle with EPB applied. It may cause excessive
brake pad and brake rotor wear.
To apply EPB (Electronic Parking Brake):
1. Depress and hold the brake pedal.
2. Pull up the EPB switch.
Make sure the Parking Brake warning light comes on...
To release EPB, fasten seatbelt and close door, hood and liftgate
If you try to drive with EPB applied, a warning will sound and a message
will appear...
Other information:
The SRS consists of the following components:
(1) Driver's front air bag module
(2) Passenger's front air bag module
(3) Side air bag modules
(4) Curtain air bag modules
(5) Retractor pre-tensioner
(6) Air bag warning light
(7) SRS control module (SRSCM)/ Rollover sensor
(8) Front impact sensors
(9) Side impact sensors
(10) Side pressure sensors
(11) Seat belt buckle sensor
(12) Emergency fastening device system
(13) Occupant classification system
The SRSCM continually monitors all SRS components while the ignition switch is
ON to determine if a crash impact is severe enough to require air bag deployment
or pre-tensioner seat belt deployment...
Replacement
1.
Using a Lwrench, remove the cap (A) on the bottom of the receiver-drier.
2.
Remove the receiver-drier (A) from condenser using a long nose plier.
Check for crumbled receiver-drier and clogged bottom cap filter...
Categories
1. Instrument cluster
2. Driver’s front air bag
3. Engine Start/Stop button
4. Infotainment system
5. Hazard warning lamp switch
6. Climate control system
7. Shift button
8. ISG (Idle Stop and Go) button
9. Auto Hold button
10. Heated steering wheel button
11. Drive mode button
12. DBC (Downhill Brake Control) button
13. Parking Safety button
14. Parking/View button
15. Air ventilation seat button
16. Seat warmer
17. Passenger’s front air bag
18. Glove box
19. Wireless charging system pad
20. Cup holder
21. AC inverter
22. USB charger
read more