Hyundai Santa Fe (TM): Airbag Module / Passenger Airbag (PAB) Module. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module. Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Disconnect the passenger airbag connector (A) & (B).
4.
Remove the main crash pad.
(Refer to Body - "Main Crash Pad Assembly")
  
•
Replace the crash pad which is damaged while PAB is deployed.
5.
Loosen the mounting bolt and then remove the PAB.

  
•
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Installation
1.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
2.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts (A).
Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

3.
Install the main crash pad.
(Refer to Body - "Main Crash Pad Assembly")
4.
Tighten the passenger airbag mounting bolts and then connect the passenger airbag harness connector.
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-.ft)
5.
install the Glove box housing
(Reper Body - "Glove Box" )
6.
Reconnect the battery cable(-)
7.
After installing the passenger airbag, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

    Components 1. Passenger airbag (PAB)

    Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when a side crash occurs.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: PTC Heater (Diesel only). Description and operation

    Description The PTC (Positive Temperature Coefficient) heater is installed at the exit or the backside of the heater core. The PTC heater is an electric heater using a PTC element as an auxiliary heating device that supplements deficiency of interior heat source in highly effective diesel engine.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Auto Defogging Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 6.

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0167