Hyundai Santa Fe: Evaporative Emission Control System / Fuel Tank Air Filter. Repair procedures
•
|
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift.
(Refer to General Information - "Lift and Support Points")
|
|
1. |
Turn the ignition switch OFF and disconnect the battery (-) terminal.
|
3. |
Remove the rear-left wheel & tire and wheel house cover.
|
4. |
Separate the ventilation hoses (A).

|
5. |
Remove the fuel tank air filter (A) after loosening the mounting bolts.
Tightening torque :
7.9 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
|

|
1. |
Install in the reverse order of removal.
|
Description
A ratchet tightening device on the threaded fuel filler cap reduces the chances
of incorrect installation, which seals the fuel filler...
Other information:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the injector terminals 1 and 2.
4...
Inspection
1.
Connect the diagnostic tool on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C...
Categories

1. Instrument cluster
2. Driver’s front air bag
3. Engine Start/Stop button
4. Infotainment system
5. Hazard warning lamp switch
6. Climate control system
7. Shift button
8. ISG (Idle Stop and Go) button
9. Auto Hold button
10. Heated steering wheel button
11. Drive mode button
12. DBC (Downhill Brake Control) button
13. Parking Safety button
14. Parking/View button
15. Air ventilation seat button
16. Seat warmer
17. Passenger’s front air bag
18. Glove box
19. Wireless charging system pad
20. Cup holder
21. AC inverter
22. USB charger
read more