Hyundai Santa Fe (TM): Fuel Delivery System / Fuel Pressure Regulator. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pressure Regulator. Repair procedures

Removal
1.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump")
2.
Disconnect the fuel sender connector (A).
3.
Release the fixing hook (A) and then remove fuel sender (B) in the arrow direction.
4.
Remove the fixing pin (A) and then disconnect the fuel feed tube (B).
5.
Disconnect the fuel pump motor connector (A).
6.
Release the fixing hook (A) and then remove the head assembly (B).
7.
Release the fixing hook (A) and then remove the reservoir-cup (B).
8.
Disconnect the fuel pump motor connector (A).
9.
Disconnect the ground cable (B).
10.
Remove the fixing pin (A) and then disconnect the fuel pressure regulator (B).
Installation
1.
Install in the reverse order of removal.

    Removal 1. Remove the fuel pump. (Refer to Fuel System - "Fuel Pump") 2. Disconnect the fuel sender connector (A).

    Removal    • Be careful not to damage the parts located under the vehicle (floor under cover, canister, fuel tank) when raising the vehicle using the lift.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Front View Camera Unit. Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the inside rear view mirror cover (A) and front view camera cover (B). 3.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Troubleshooting

    Troubleshooting    1) After replacing controller, always check that the system operates properly. 2) If the failure persists after replacing the controller, do not replace th

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.016