Hyundai Santa Fe: Fuel Delivery System / Fuel Filter. Repair procedures

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Filter. Repair procedures

Removal

1.	Remove the fuel pump. (Refer to Fuel System - "Fuel Pump")

2.	Disconnect the fuel sender connector (A).

3.	Release the fixing hook (A) and then remove fuel sender (B) in the arrow direction.

4.	Remove the fixing pin (A) and then disconnect the fuel feed tube (B).

5.	Disconnect the fuel pump motor connector (A).

6.	Release the fixing hook (A) and then remove the head assembly (B).

7.	Release the fixing hook (A) and then remove the reservoir-cup (B).

8.	Disconnect the fuel pump motor connector (A).

9.	Disconnect the ground cable (B).

10.	Remove the fixing pin (A) and then disconnect the fuel pressure regulator (B).

11.	Release the fixing hook and then remove the assist pump (A).

12.

Separate the fuel pump hose (A) after releasing the clamp (B).

•	Replace the clamp with a new one when reinstalling the clamp.

13.	Remove the pump filter & fuel pump (A) after releasing the hooks.

14.	Release the fixing hook and then remove the fuel filter (A) from the bracket (B).

Installtion

1.	Install in the reverse order of removal.

Fuel Pump. Repair procedures

Inspection [Fuel Pump] 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2...

Fuel Pump Motor. Repair procedures

Removal 1. Remove the fuel pump. (Refer to Fuel System - "Fuel Pump") 2. Disconnect the fuel sender connector (A)...

Other information:

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Description and operation

Description If the Gasoline Engine Control system components (sensors, ECM, injector, etc.) fail, interruption to the fuel supply or failure to supply the proper amount of fuel for various engine operating conditions will result...

Hyundai Santa Fe (TM) 2019-2025 Service Manual: Lift and Support Points

Lift and Support Points [Two-Post Car Lift] 1. Place the lift blocks under the support points as shown in the illustration. 2. Raise the hoist a little and visually check that the lift block is properly seated on the vehicle support point...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.