Hyundai Santa Fe (TM): ESP(Electronic Stability Program) System / Emergency Signal System. Description and operation

Description
Introduction of quick brake warning system (ESS)
In case of quick brake by driver, the brake lamp or turn signal is blinked to warn against the vehicle at rear.

1.
Basic function (Blinking the brake lamp/emergency lamp)
–
Operation condition : In case of quick brake or operation of ABS above in a certain speed
–
Releasing condition : In case of stopping the quick brake or releasing the ABS operation
2.
Additional function (Blinking the turn signal)
–
Operation condition : In case of quick brake in low speed
–
Releasing condition : Releasing at the start of driving

System Configuration

ESS Circuit Diagram

    Removal    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.

    Description The yaw rate and G sensor is included inside the air bag control module (SRSCM). When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate sensor.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Fuses And Relays

    Components and components location Component Location 1. Engine room relay box 2. Sub relay box 3. ICU Junction block 4. ICM relay box Relay Box (Engine Compartment).

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Compressor. Description and operation

    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.

    Categories

     
    Copyright © 2026 www.hsafe4.com - 0.0339