Hyundai Santa Fe (TM): Crankcase Emission Control System / Crankcase Check Valve. Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Emission Control System / Crankcase Emission Control System / Crankcase Check Valve. Repair procedures

Removal and Installation
  
•
Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
(Refer to General Information - "Lift and Support Points")
1.
Disconnect the battery (-) terminal.
2.
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the drive belt.
(Refer to Drive Belt System - "Drive Belt")
4.
Remove the compressor mounting bolts.
(Refer to Heating, Ventilation and Air Conditioning - "Compressor")
5.
Disconnect the crankcase check valve hose (A) and then remove the crankcase check valve (B).
Tightening torque :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

  
•
Push the check valve to the end of the mounting surface, and then tighten the bolt.

    Removal 1. Remove the cylinder head cover. (Refer to Engine Mechanical System - "Cylinder Head Cover") Installation 1.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Temperature Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Remote Smart Parking Assist (RSPA). Repair procedures

    Removal ADAS Parking ECU (ADAS_PRK) 1. Disconnect the negative (-) battery terminal. 2. Remove the ADAS Parking ECU (ADAS_PRK). (Refer to Advanced Driver Assistance System (ADAS) - "ADAS Parking ECU (ADAS_PRK)") Parking/View switch

    Categories

     
    Copyright © 2025 www.hsafe4.com - 0.0136