Hyundai Santa Fe: Lubrication System / Balance Shaft Module. Repair procedures
		
		
		
	
		| 
			
				| • | 
					Be careful not to damage the parts located under the vehicle 
					(floor under cover, fuel filter, fuel tank and canister) when 
					raising the vehicle using the lift. 
					(Refer to General Information - "Lift and Support Points") |  | 
	
		| 1. | 
			Remove the oil pump. 
			(Refer to Lubrication System - "Oil Pump") | 
	
		| 2. | 
			Remove the balance shaft module (A). 
		 
			
				| 
					
						| • | 
							When removing the BSM, remove it in sequence as below 
							picture. 
						 |  |  | 
	
		| 1. | 
			Install the balance shaft module (A). 
		 
			
				| 
					
						| • | 
							When installing the balance shaft module, tighten the 
							bolts with pre-torque first, and then tighten the bolts 
							and nuts with specified torque in the sequence shown. 
							1 STEP : Tighten the bolts in sequence as below picture. 
						 
							2 STEP : Loosen the bolts in sequence as below picture. 
						 
							3 STEP : Tighten the bolts in sequence as below picture. 
							
								| 
									Tightening torque :  
									17.7 - 21.6 N.m (1.8 - 2.2 kgf.m, 13.0 - 15.9 
									lb-ft) + 58° - 62° |  
						 |  |  | 
	
		| 2. | 
			Install the oil pump. 
			(Refer to Lubrication System - "Oil Pump") | 
   
	
		Oil and filter replacement
	
	
		
		
			
				
				
				   
			
			
				
			
		
		
			
				•
				
				
				
					Be careful not to damage the parts located under the vehicle 
					(floor under cover, fuel filter, fuel tank and canister) when 
					raising the vehicle using the lift...
   
 
   
	
		Removal
	
	
		
		
			
				
				
				   
			
			
				
			
		
		
			
				•
				
				
				
					Be careful not to damage the parts located under the vehicle 
					(floor under cover, fuel filter, fuel tank and canister) when 
					raising the vehicle using the lift...
   
 
   Other information:
   
	
		Replacement
	
	
		
		1.
		
		
			Disconnect the negative (-) battery terminal.
		
	
	
		
		2.
		
		
			Remove the heater and blower assembly.
		
			(Refer to Heater - "Heater Unit")
		
	
	
		
		3.
		
		
			Loosen the mounting screws and remove the heater core cover (A)...
   
   The remote key will not work if any of the following occur:
	The key is in the ignition switch.
	You exceed the operating distance limit (about 10 m [30 feet]).
	The remote key battery is weak.
	Other vehicles or objects may be blocking the signal.
	The weather is extremely cold...
   
 
	 
	
        
		Categories
		
		
Vehicle Identification Number (VIN)

The vehicle identification number (VIN) is the number used in registering your 
vehicle and in all legal matters pertaining to its ownership, etc.
The number is punched on the floor under the passenger seat. To check the number, 
open the cover.
read more