Hyundai Santa Fe: Heater / Auto Defogging Actuator. Components and components location

1. Auto defogging
actuator
|
|
Description
The auto defogging sensor is installed on the front window glass. The sensor
judges and sends signal if moisture occurs to blow out wind for defogging...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector...
Other information:
Description
The ignition coil is a kind of small transformer that transforms the battery
voltage to 30 kV or more to create a spark in the spark plug gap in the cylinder.
The igniter embedded in the ignition coil includes the power transistor and
it is an electronic switch whose electric current is controlled by the Engine
Control Module (ECM) signal...
1. After driving approximately 4~6 miles (7~10 km or about 10 minutes), stop
at a safe location.
2. Connect the connection hose (3) of the compressor and tire into the tire valve.
3. Connect cables (4) to the battery.
4. Adjust the tire inflation pressure to the recommended tire inflation...
Categories

1. Instrument cluster
2. Driver’s front air bag
3. Engine Start/Stop button
4. Infotainment system
5. Hazard warning lamp switch
6. Climate control system
7. Shift button
8. ISG (Idle Stop and Go) button
9. Auto Hold button
10. Heated steering wheel button
11. Drive mode button
12. DBC (Downhill Brake Control) button
13. Parking Safety button
14. Parking/View button
15. Air ventilation seat button
16. Seat warmer
17. Passenger’s front air bag
18. Glove box
19. Wireless charging system pad
20. Cup holder
21. AC inverter
22. USB charger
read more