Hyundai Santa Fe: Starting System / Troubleshooting

Hyundai Santa Fe (TM) 2019-2024 Service Manual / Engine Electrical System / Starting System / Troubleshooting

Troubleshooting

•	The battery must be in good condition and fully charged for this troubleshooting.

Trouble symptom	Probable cause	Remedy
Engine will not crank	Battery charge low	Charge or replace battery
	Battery cables loose, corroded or worn out	Repair or replace cables
	Transaxle range switch (Vehicle with automatic transaxle only)	Refer to AT group-automatic transaxle
	Fuse blown	Replace fuse
	Starter motor faulty	Replace
	Ignition switch faulty	Replace
Engine cranks slowly	Battery charge low	Charge or replace battery
	Battery cables loose, corroded or worn out	Repair or replace cables
	Starter motor faulty	Replace
Starter keeps running	Starter motor faulty	Replace
Starter keeps running	Ignition switch	Replace
Starter spins but engine will not crank	Short in wiring	Repair or replace wiring
	Pinion gear teeth broken or starter motor	Replace
	Ring gear teeth broken	Replace fly wheel or torque converter

Description and operation

Description The starting system includes the battery, starter, solenoid switch, ignition switch, ignition lock switch, connection wires and the battery cable...

Starter. Description and operation

Description The starting system includes the battery, starter, solenoid switch, ignition switch, ignition lock switch, connection wires and the battery cable...

Other information:

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Description and operation

Description The optimal seat position set by the driver is memorized into the power seat unit by using IMS switch. In case of the position change, the seat can restore its preset position by IMS switch. It has safety functions of restoring process prohibition during driving and of emergency stop of the linked motion...

Hyundai Santa Fe (TM) 2019-2024 Service Manual: Hood Latch. Repair procedures

Replacement 1. Remove the front bumper assembly. (Refer to Front Bumper - "Front Bumper Assembly") 2. Press the rock pin to separate the hood latch connector (A) and disconnect wiring clip...