Hyundai Santa Fe (TM): Body Electrical System / Special service tools

Special Service Tools
Tool (Number and Name)
Illustration
Application
Correction jig for LDW or LKA
(09890-3V100)

Correction of LDW (Lane Departure Warning) or LKA (Lane Keeping Assist).
Vertical Measuring Device
(09964-C1200)

Correction front view camera
RKE Battery Checker
(09954-2P100)

Measuring the RKE battery voltage.
Blind-Spot Radar Unit Correction Tool Set
(09958-3T500)

Used to correct the Blind-Spot Radar unit.
Vertical Plumb
(09958-3T010)

Used to correct the Blind-Spot Radar unit.Used to create a center line.
(Use with 09958-3T020, 09958-3T030, 09958-3T040, 09958-3T060)
Spirit Level
(09958-3T070)

Used to correct the Blind-Spot Radar unit.Used to measure the horizontal angle.
(Use with 09958-3T080, 09958-3T090, 09958-3T120)
Blind-Spot Radar Unit Fixing Adaptor
(09958-3T080)

Used to correct the Blind-Spot Radar unit.Used to measure the horizontal angle.
(Use with 09958-3T070, 09958-3T090, 09958-3T120)
Digital Protractor
(09958-3T090)

Used to correct the Blind-Spot Radar unit.Used to measure the horizontal angle.
(Use with 09958-3T070, 09958-3T080, 09958-3T120)
Digital Inclinometer
(09958-3T100)

Used to correct the Blind-Spot Radar unit.Used to measure the vertical angle.
Case & Manual & String
(09958-3T120)

Used to correct the Blind-Spot Radar unit to measure the horizontal angle.

    General Troubleshooting Information Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box.

    Components and components location Component Location 1. Audio unit 2. Tweeter speaker 3. Roof antenna (Radio) 4.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Smart Key. Repair procedures

    Smart Key Smart Key Code Saving 1. Connect the DLC cable of diagnostic tool to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on diagnostic tool. 2.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Auto Defogging Sensor. Repair procedures

    Inspection To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the rain sensor inner cover (A) and rain sensor cover (B).

    Categories

     
    Copyright В© 2026 www.hsafe4.com - 0.0194