Hyundai Santa Fe (TM): Restraint / Repair procedures

Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual / Restraint / Repair procedures

Component Replacement after Deployment
  
•
Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.
When the front airbag(s) deployed after a collision, replace the following items.
–
SRSCM
–
Deployed airbag(s)
–
Seat belt pretensioner(s)
–
Front impact sensors
–
SRS wiring harnesses
–
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
When the side/curtain airbag(s) deployed after a collision, replace the following items.
–
SRSCM
–
Deployed airbag(s)
–
Side impact sensor(s) for the deployed side(s)
–
SRS wiring harnesses
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
–
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.

    Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp check.

    Components and components location Components 1. Supplemental Restraint System Control Module (SRSCM) 2. Gravity side impact sensor (G-SIS) _ C pillar 3.

    Other information:

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Smart key antenna. Repair procedures

    Removal Interior 1 Antenna    Take care not to scratch the crash pad and related parts. 1. Disconnect the negative (-) battery terminal.

    Hyundai Santa Fe (TM) 2019-2023 Service and Repair Manual: Rear Glass Defogger

    Components and components location Component Location 1. Rear glass defogger relay (Buil-in engine room relay box) 2. Rear glass defogger switch (Dual type) 3. Rear glass defogger switch (Manual type) 4.

    Categories

     
    Copyright © 2026 www.hsafe4.com - 0.027