Hyundai Santa Fe: Convenience features / Theft-alarm system
This system helps to protect your vehicle and valuables. The horn will sound
and the hazard warning lights will blink continuously if any of the following occur:
- A door is opened without using the smart key.
- The liftgate is opened without using the smart key.
- The engine hood is opened.
The alarm continues for 30 seconds, then the system resets. To turn off the alarm,
unlock the doors with the smart key.
The Theft Alarm System automatically sets 30 seconds after you lock the doors
and the liftgate. For the system to activate, you must lock the doors and the liftgate
from outside the vehicle with the smart key or by touching the touch sensor on the
outside of the door handle with the smart key in your possession.
The hazard warning lights will blink and the chime will sound once to indicate
the system is armed.
Once the security system is set, opening any door, the liftgate, or the hood
without using the smart key will cause the alarm to activate.
The Theft Alarm System will not set if the hood, the liftgate, or any door is
not fully closed. If the system will not set, check the hood, the liftgate, or the
doors are fully closed.
Do not attempt to alter this system or add other devices to it.
Information
- Do not lock the doors until all passengers have left the vehicle.
If the remaining passenger leaves the vehicle when the system is armed, the
alarm will be activated.
- If the vehicle is not disarmed with the smart key, open the doors
by using the mechanical key and start the engine by directly pressing the Engine
Start/Stop button with the smart key.
- If the system is disarmed by unlocking the vehicle, but neither
a door or the liftgate is opened within 30 seconds, the doors will relock and
the system will rearm automatically.
When the electronic child safety lock button is pressed and the indicator light
on the button illuminates, the rear doors cannot be opened from inside the vehicle...
Integrated Memory System for the driver’s seat is provided to store and recall
the following memory settings with a simple button operation.
Driver’s seat position
Side View mirror position
WARNING
Never attempt to operate the integrated memory system while the vehicle is
moving...
Other information:
Removal and Installation
•
Be careful not to damage the parts located under the vehicle
(floor under cover, fuel filter, fuel tank and canister) when
raising the vehicle using the lift...
Description
Continuous Variable Valve Timing (CVVT) system advances or retards the valve
timing of the intake and exhaust valve in accordance with the ECM control signal
which is calculated by the engine speed and load.
By controlling CVVT, the valve over-lap or under-lap occurs, which makes better
fuel economy and reduces exhaust gases (NOx, HC) and improves engine performance
through reduction of pumping loss, internal EGR effect, improvement of combustion
stability, improvement of volumetric efficiency, and increase of expansion work...
Categories
Engine oil pressure warning light
.png)
This warning light illuminates:
When the engine oil pressure is low.
If the engine oil pressure is low:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. Turn the engine off and check the engine oil level (For more details, refer
to “Engine Oil” section in chapter 9). If the level is low, add oil as required.
read more