Hyundai Santa Fe: Heater / Temperature Control Actuator. Description and operation

Hyundai Santa Fe (TM) 2019-2025 Service Manual / Heating,Ventilation And Air Conditioning / Heater / Temperature Control Actuator. Description and operation

Description
The heater unit includes mode control actuator and temperature control actuator.
The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
Signal from control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door.

    PTC Heater (Diesel only). Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the mode to FLOOR...

    Temperature Control Actuator. Components and components location

    ..

    Other information:

    Hyundai Santa Fe (TM) 2019-2025 Service Manual: Underdrive Brake Control Solenoid Valve (UD/B_VFS). Components and components location


    Component Location (1)_Valve Body Cover 1. Valve Body Cover 2. Valve Body Cover Gasket 3. Solenoid Valve Connector Component Location (2)_Solenoid Valve 1. 26 Brake Control Solenoid Valve 2...

    Hyundai Santa Fe (TM) 2019-2025 Owner's Manual: ISG system operation


    Prerequisite for activation ISG system operates in the following situations. The driver's seatbelt is fastened The driver's door and hood are closed The brake vacuum pressure is adequate The battery sensor is activated and the battery is sufficiently charged Outside temperature is not too low or too high The vehicle is driven over a constant speed and stops The climate control system satisfies the conditions The vehicle is sufficiently warmed up ISG related parts are working properly The incline is gradual The steering wheel is turned less than 180 degrees and then the vehicle stops Information If the ISG light (white) is turned on on the instrument cluster and does not meet the ISG system operating conditions, the ISG system is not activated...

    Categories

    Air bag collision sensors

    WARNING

    To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

    Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Installing bumper guards with nongenuine Hyundai or non-equivalent parts may adversely affect the collision and airbag deployment performance. Press the Engine Start/Stop button to the OFF or ACC position and wait for 3 minutes when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs performed by an authorized HYUNDAI dealer.

    read more


     
    Copyright © 2025 www.hsafe4.com